STARTRITE 352E Original Instruction Manual page 13

6.8 TABLE INSERT FOR DUST EXTRACTION
The machines are equipped with a removable plastic insert under the work-
table(A of FIG.6.11), the insert improves dust extraction. It is recommended
that the insert " A " be replaced when the blade cutting clearance widens,
this will maintain maximum efficiency of dust extraction.
6.9 CUTTING DIRECTION AND PARALLELISM
If the cut is not perfectly parallel when using the parallel rip fence the
possible causes are:
• Incorrect grinding and setting of the blade
• Insufficient blade tension
• Incorrect setting of the parallel rip fence in respect of the saw blade;
to adjust the parallelism of the guide, slacken, without removing, the 2
screws (B of FIG. 6.11), adjust the guide position and firmly re-tighten the
2 screws.
6.10 TILTING THE WORK TABLE
The table can be tilted to a maximum of 20°
To incline it, loosen off the locking ratchet handle (FIG. 6.12).
position A. Turn the table by hand until table is at required angle.
FIG. 6.11
FIG. 6.12
B
A
A
12 13