Resetting/Initializing The Scanner; Resetting The Scanner - Radio Shack PRO-70 Owner's Manual

20-310.fm Page 49 Wednesday, August 4, 1999 10:49 AM
RESETTING/INITIALIZING THE
SCANNER
If the scanner's display locks up or does not work properly
after you connect a power source, you might need to reset
or initialize the scanner.
IMPORTANT! If you have problems, first try to reset the
scanner (see "Resetting the Scanner"). If that does not
work, you can initialize the scanner (see "Initializing the
Scanner" on Page 50); however, this clears all information
stored in your scanner's memory.

Resetting the Scanner

1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper
clip, into the reset opening on the side of the scanner
(as shown below) and gently press then release the
reset button inside the opening.
Note: If the scanner still does not work properly, you might
need to initialize the scanner (see "Initializing the Scan-
ner" on Page 50).
49