Advertisement
Place the Bottom Panel (P-3) with the Pre-
11.
drilled holes facing up and install 4 Cam
Locks (C) in the 4 large holes as shown in
illustration # 4.
Attach 2 Hinges (R) to the
12.
CPU Door (P-16) using 6 Screws
(A5) as shown in illustation #5.
Attach Door Knob (P) to CPU
13.
Door (P-16) using 1 screw (A6).
14.
Attach Strike Plate (K1) to CPU
Door (P-16) using 1
screw (A4).
A5
R
Illustration # 5
15.
Insert 1 each Lock Cylinder(G) through the Lock
Plate (J) and the hole in the CPU Door (P-16).
Secure Lock Cylinder (G) using the Lock Washer (L) and the Lock
Hex (M). (F
INGER
16.
Slide Lock Retainer (H) over the square end of Lock Cylinder (G).
Secure using the ¼" Phil Head Lock Screw (A8). Before tightening
the Lock Hex (M), Insert the Key (N) and turn lock. Be sure lock is
aligned with Key slot as shown in Illustration #5A.
T
L
H
IGHTEN
OCK
EX
P-3
A5
R
T
O
.)
IGHTEN
NLY
(M)
C
A5
P-16
A8
H
M
L
J
G
5
Illustration # 4
Be sure that arrow on
top of Camlock (C)
aligns with centerline of
Edge Drilled hole.
P-1
Centerline of
A4
Edge Drilled
hole.
K1
A6
P
Illustration # 5A
H
G
Door
Front view
Locked Position
Phillips
Screwdriver
Arrow
Advertisement
