Advertisement
Place the Left Side Panel (P-1) with the Predrilled holes facing up and install 2 Cam Posts (D)
4.
in the 2 threaded insert nuts (Pre-installed) as shown in illustration # 2.
5.
Install 2 Cam Locks (C) in the 2 large holes.
6.
Install 8 Wood Dowels (E) into the holes as shown in illustration # 2.
7.
Attach Magnet (K) using 2 Screws (A7).
Phillips
Screwdriver
Arrow
P-1
Centerline of
Edge Drilled
hole.
Note:
Camlocks can be turned with Allen Wrench,
or Large Phillips Screwdriver
Place the Right Side Panel (P-2) with the Predrilled
8.
holes facing up and install 2 each Cam Posts (D) in
the 2 threaded insert nuts (Pre-installed) as shown
in illustration # 3.
9.
Install 2 each Cam Locks (C)
in the 2 large holes.
10.
Install 8 Wood Dowels (E)
into the holes as shown
in illustration # 3.
Do not use unless all screws are tight. At least every six months, check all screws to be
sure they are tight. If parts are missing, broken, damaged, or worn, stop use
of the product until repairs are made by your dealer using factory authorized parts.
C
Be sure that arrow on
top of Camlock (C)
aligns with centerline of
Edge Drilled hole.
D
K
C
E
E
D
4
D
A7
Illustration # 2
C
P-2
Illustration # 3
E
P-1
E
Advertisement
