Input Name Reset - NEC MultiSync C431 User Manual

External control
Hide thumbs Also See for MultiSync C431:
Table of Contents

Advertisement

19.3 Input Name Reset

This command is used in order to reset the Input Name.
1) The controller requests the monitor to reset Input Name.
Header
SOH-'0'-Monitor ID-
'0'-'A'-'0'-'8'
Header
SOH (01h): Start of Header
'0' (30h): Reserved
Monitor ID: Specify the Monitor ID of which you want to change a setting.
Ex.) If Monitor ID is '1', specify 'A'.
'0' (30h): Message sender is the controller.
'A' (41h): Message type is "Command".
'0'-'8'(30h, 38h): Message length (8bytes)
Message
STX (02h): Start of Message
'C'-'A'-'0'-'4' (43h, 41h, 30h, 34h): Input Name Command
'0'-'2' (30h. 32h): Reset
ETX (03h): End of Message
Check code
BCC: Block Check Code
Refer to the section 4.3 "Check code" for a BCC calculation.
Delimiter
CR (0Dh): End of packet
2) The monitor replies result.
Header
SOH-'0'-'0'-Monitor ID-
'B'-'0'-'A'
Header
SOH (01h): Start of Header
'0' (30h): Reserved
'0' (30h): Message receiver is the controller.
Monitor ID: Indicate a replying Monitor ID.
Ex.) When this byte is set to 'A', replying monitor's ID is '1'.
'B' (42h): Message type is "Command reply".
'0'-'A'(30h, 41h): Message length (10bytes)
Message
STX (02h): Start of Message
'C'-'B'-'0'-'4' (43h, 42h, 30h, 34h): Input name Command
'0'-'2' (30h, 32h): Reset
ST: Status
00h (30h, 30h): No Error
01h (30h, 31h): Error
ETX (03h): End of Message
Check code
BCC: Block Check Code
Refer to the section 4.3 "Check code" for a BCC calculation.
Delimiter
CR (0Dh): End of packet
Message
STX-'C'-'A'-'0'-'4'-'0'-'2'-ETX
Message
STX-'C'-'B'-'0'-'0'-'0'-'2'-ST-ETX
(85/104)
Check code
Delimiter
BCC
CR
Check code
Delimiter
BCC
CR

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MultiSync C431 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Multisync c501Multisync c551

Table of Contents