Configuring Routing Information Protocol (Rip) - NETGEAR ProSafe SRXN3205 Reference Manual
Wireless-n vpn firewall
Hide thumbs
Also See for ProSafe SRXN3205:
- Datasheet (4 pages) ,
- Reference manual (218 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Configuring Routing Information Protocol (RIP)
RIP (Routing Information Protocol, RFC 2453) is an Interior Gateway Protocol (IGP) that is
commonly used in internal networks (LANs). It allows a router to exchange its routing information
automatically with other routers, and allows it to dynamically adjust its routing tables and adapt to
changes in the network. RIP is disabled by default.
To configure RIP parameters:
1. Select Network Configuration > Routing from the main/sub-menu.
2. Click the RIP Configuration link to the right of the tab.
The RIP Configuration menu displays.
Figure 3-7OK
3. From the RIP Direction pull-down menu, choose the direction in which the VPN Firewall
will send and receive RIP packets. The choices are:
•
None. The VPN Firewall neither broadcasts its route table nor does it accept any RIP
packets from other routers. This effectively disables RIP.
LAN Configuration
ProSafe Wireless-N VPN Firewall SRXN3205 Reference Manual
v1.0, July 2008
3-13
Advertisement
Table of Contents
