WASHING MACHINE B1113JDW/XAC ERVICE Manual WASHING MACHINE CONTENTS Caution for safety during servicing 1. SPECIFICATIONS 2. OVERVIEW OF THE WASHING MACHINE 3. OVERVIEW OF THE CONTROL PANEL 4. GENERAL ERROR FUNCTION 5. TROUBLE DIAGNOSIS 6. TEST MODE 7. DESIGNATION OF MAIN COMPONENTS 8.
Caution for safety during servicing 1. Do not allow the customer to repair the product. The person may be injured or the product life may be shortened. 2. Execute A/S after unplugging the power supply unit. Be careful of electric shocks. 3.
1. Specifications FRONT LOADING TYPE WASH TYPE GROSS W 680mm X D 665mm X H 890mm DIMENSIONS W 598mm X D 550mm X H 844mm WATER PRESSURE 50 kPa ~ 800 kPa GROSS 78 kg WEIGHT 75 kg WASH and SPIN CAPACITY 5.5 kg (DRY LAUNDRY) POWER CONSUMPTION WASHING...
4. General Error Function - When an error occurs, this function starts to keep generating error melody sounds and displays error indicators as shown in the followings per corresponding error by blinking in 0.5sec intervals until the error status is completely cleared out. In this case, all the driving devices are turned off until the error is cleared out.
5. Trouble Diagnosis As the micom washing machine is configured of a complicated structure, there might be a need for a service call. The information below is prepared for exact trouble diagnosis and suitable repair guide. Caution for the Repair and Replacement Please follow instructions below for trouble diagnosis and parts replacement.
Page 8
5-1. Trouble Diagnosis Item Cause and treatment The power is not supplied - Is the PCB connector connected well? - Is the voltage normal? - Is the power supply plug connected well? - Is the noise filter connected well? - Is the secondary output of the power supply transformation normal? - Is the fuse disconnected? (option) •...
6. TEST MODE 1. Driving Compartment Test Mode A. Hold down “ 1” and “ 2” keys simultaneously and then press POWER S/W “ 4” on. (Whole lamps turn on and display show “ t1” after 3 Seconds.) B. The driving compartment can be tested when you press “ 3” key right after entering into the initial stage of the TEST MODE.
7. Designation of Main Components 7-1 Normal / Reverse Revolution of Motor and R. P. M. Control 1 2 3 4 5 6 7 8 9 10 Rotor Stator coil Rotor Stator coil STATOR WASHING MOTOR <Figure1> <Figure2> DC31-00002D 7-2 Door safety Device DC61-20205B - 9 -...
9. Assemble and Disassemble 1. ASS’ Y-COVER TOP 1) Remove two screws fixing the top-cover to back side. SCREW 2) Push the top-cover back about 15mm and pull it up. 3) It’ s possible to exchange and service Assy-Panel (PCB), the pressure-sensor, the noise-filter, the water valve and trans(option).
Page 16
9. Assemble and Disassemble 3. BELT 1) Remove the top-cover. 2) Disassemble and assemble the belt. 3) Check that the belt is located at center of the motor-pulley. <When assembling the belt> Hook the belt onto the motor pulley 1) and place it around the pulley 2).
10. Tools for Disassembly and Assembly TOOL 10mm Heater (1) 13mm Motor (1), Balance (5) À Box driver 17mm 2 holes on each left and right of the shock absorber 19mm 1 Pulley hole Replaceable for the box driver. Double-ended 10, 13 Á...