Advertisement
CHAPTER 8
LanXPLORER Firmware Update
The LanXPLORER firmware should be updated at regular intervals. Please contact Technical support
for the latest firmware upgrades.
The LanXPLORER firmware can be updated using as USB storage device.
NOTE:
Before updating the firmware, make a backup of the test data on the LanXPLORER. When updating
the firmware, power should be supplied to the LanXPLORER using the charger/power pack or ensure
that the rechargeable batteries are fully charged. Data export and data import is accomplished
exclusively to/from a USB storage device connected to the LanXPLORER.
1. Store the firmware update on an empty USB storage device.
2. Plug the USB storage device into the USB interface on the LanXPLORER.
3. Switch on the LanXPLORER.
4. Ensure that the rechargeable batteries in the LanXPLORER
are charged or connect the LanXPLORER to mains power.
5. Select the menu point Setup.
6. Select the menu point "System".
7. Select the menu point "Update".
8. Update the software. You can exit the menu without saving
the changes with Cancel or Escape.
9. Select "Confirm" to start the update.
10. Wait until the update has concluded and the main menu
appears on the LanXPLORER display after restarting.
11. Remove the USB storage device.
NOTE:
Depending on the update, the LanXPLORER will re-start automatically or requires a manual re-start.
Advertisement
