Installation, Instructions And Intended Use - Revolutionary Science Saniclave 200 Instruction Manual

Installation Instructions
Remove Saniclave 200 from packaging and place it on a dry level surface. Plug it into an
accessible 120 VAC power receptacle. For printer setup, see page 6. The Saniclave 200 is
now ready for use. See operating instructions on page 7.
Upon receiving the Saniclave 200, it is important that you follow these simple steps:
1. Examine carton and contents for possible damage to the product caused during shipping.
If damage is
release the carrier from any liability of damage.
2. Fill out the checklist (see instruction manual). If the shipment is incomplete, please
contact us at
3. Carefully read this instruction manual before operating the Saniclave 200.
4. Fill out warranty registration card and mail it to
Revolutionary Science
17319 Lake Blvd.
Shafer, MN 55074.
Intended Use
The Revolutionary Science Saniclave 200 is designed to be used in medical and dental clinics,
hospitals and other facilities where reusable sterile equipment is used. It is intended to sterilize
wrapped and unwrapped heat and moisture stable solid instruments, mated surfaces, knurled
and hinged devices (excluding lumened devices and dental hand pieces) that are compatible
with saturated steam sterilization at 121 degrees Celsius for 30 minutes.
present contact carrier at once. Failure to do so immediately may
support@revsci.com or 651-257-0633.
4