JVC AV-29R9B Instructions Manual page 29

                                               
 
1
Connect the TV's VIDEO jack and the de-
vice's VIDEO OUT (video output) jack with
a video cable.
If connecting a device to the TV with an S-VID-
EO cable:
Connect the VCR's S-VIDEO OUT (S-VIDEO output)
connector and the TV's S connector with an S-VIDEO
cable, instead of connecting with a video cable.
Note that the connection with a video cable will be ig-
nored in case you connect a VCR to the TV with both vid-
eo cable and S-VIDEO cable.
If connecting a DVD player to the TV with a
component video cable:
Connect three jacks (Y/VIDEO, C
EO-3 terminal and the DVD player's COMPONENT
(composite video output) jacks with a component video
cable, instead of connection with a video cable. Then set
the VIDEO-3 SETTING to COMPONENT, according to
"VIDEO-3 SETTING" on page 22.
If connecting a device to the VIDEO-3/COMPO-
NENT terminal with a video cable:
Connect the TV's Y/VIDEO jack and the device's VIDEO
OUT (video output) jack with a video cable. Then set the
VIDEO-3 SETTING to VIDEO according to "VIDEO-3
SETTING" on page 22.
Note:
•
2
Connect the TV's AUDIO jacks (L/MONO
and R) and the device's AUDIO OUT (audio
L/R output) jacks with an audio cable.
If the device's sound output is in mono:
Connect the device's AUDIO OUT jack and the TV's L/
MONO jack with an audio cable.
Note:
•
If the device has an AV COMPU LINK terminal:
If you connect the TV's AV COMPU LINK terminal and the de-
vice's AV COMPU LINK terminal with an AV COMPU LINK
cable, you can use the AV COMPU LINK remote control sys-
tem. For details, see "AV COMPU LINK" on page 8.




                                ! ! ! !                                  
% % % % & & & &         & & & &                        
The signals of the image and sound you are currently viewing
with this TV are output through the OUTPUT terminal. By con-
necting a VCR to the OUTPUT terminal, you can record the
currently shown image and sound to that VCR. To do this,
connect the VCR and OUTPUT terminal following the steps
below.
Note:
•
•
and C ) in the VID-
B R
Connect the headphones with a stereo mini
jack (of 3.5 mm in diameter) to the Headphone
jack at the TV front panel.
Note:
•
     
1
Connect the VIDEO jack in the OUTPUT
terminal and the VCR's VIDEO IN (video in-
put) jack with a video cable.
2
Connect the AUDIO jacks (L and R) in the
OUTPUT terminal and the VCR's AUDIO IN
(audio L/R input) jacks with an audio cable.




                        + + + +