JVC AV-29R9B Instructions Manual page 2

  



                            




                                              
If not connecting a VCR to the TV:
Connect the aerial cable to the TV's aerial socket (see A in
the illustration).
1
Connect the aerial cable to the VCR's
ANT. IN (aerial input) socket.
2
Connect the VCR's RF OUT (aerial out-
put) socket and the TV's aerial socket
with an RF cable (75-ohm coaxial ca-
ble).
3
Connect the VCR's VIDEO OUT (video
output) jack and the TV's VIDEO jack
with a video cable.
To connect a VCR to the TV with an S-VIDEO
cable:
Connect the VCR's S-VIDEO OUT (S-VIDEO output)
connector and the TV's S connector with an S-VIDEO
cable, instead of connecting with a video cable (see B in
the illustration).
Note that the connection with a video cable will be ig-
nored in case you connect a VCR to the TV with both vid-
eo cable and S-VIDEO cable.
4
Connect the VCR's AUDIO OUT (audio
L/R output) jacks and the TV's AUDIO
jacks (L/MONO and R) with an audio ca-
ble.
If the VCR's audio output is in mono:
Connect the VCR's AUDIO OUT (audio output) jack and
the TV's AUDIO L/MONO jack with an audio cable.
If the VCR is equipped with an AV COMPU LINK terminal:
If you connect the TV's AV COMPU LINK terminal and the
VCR's AV COMPU LINK terminal with an AV COMPU LINK
cable, you can use the AV COMPU LINK remote control sys-
tem (see C in the illustration). For details, see "AV COMPU
LINK" on page 8.
Note:
•
•
•
•
If your aerial cable is a 300-ohm ribbon cable:
Attach the 300-ohm ribbon cable D to the matching aerial
adapter E (provided), as shown in the illustration.


        



    
AUDIO
R L/MONO VIDEO S
OVER
VIDEO-1
VIDEO-2
C C Y/VIDEO
R B
VIDEO-3/
R AUDIO L/MONO COMPONENT
OUTPUT
R L VIDEO
AUDIO
AV COMPULINK