Hyundai HYCH7070 User Manual page 22

7.8.3. A piece of cardboard of the right thickness is usually a good gap gauge for
resetting the wear plate. The wear plate can be adjusted through the
mounting slots. Always make sure these bolts are properly tightened.
7.8.4. Remove the feed hopper and use a wooden stick to rotate the cutting disk to
make the knives positioned next to the wear plate. Slide the gap gauge in
between the knives and wear plate to check the clearance.
7.8.4.1. If the gap gauge slides freely, with no resistance and a lot of extra
space, the wear plate must be adjusted.
Page 22