Toshiba DMF102XKU Owner's Manual page 14

M M M F F O O
14
EDIA EDIA EDIA RAME RAME VERVIEW VERVIEW
Do not expose the remote sensor of the
Digital Media Frame to a strong light
source such as direct sunlight or other
illumination. If you do so, you may not
be able to operate the Digital Media
Frame via the remote control.
•
Do not drop or give the remote
control a shock.
•
Do not leave the remote control near
an extremely hot or humid place.
•
Do not spill water or put anything wet
on the remote control.
•
Do not disassemble the remote
control.
•
If the remote control does not func-
tion correctly or if the operating range
becomes reduced, replace the battery
with new one.
•
Inserting a battery other than the
specified one or an object may damage
the remote control.
■
Replace Battery of the
Remote Control
Insert the specifi ed battery to the
remote control.
1
Push the battery compartment lid
slightly in the direction illustrated.
2
Gently insert a fingernail in groove.
3
Pull out the holder in the direction
illustrated. (*Take care not to break your
fingernail.)

PUSH
4
Remove the old battery.
5
Place a new coin-shaped battery
(CR2025) with the + side up on the
holder. Keep the holder horizontal so
that the battery does not fall through.
C C AUTION AUTION
♦ Danger of explosion if battery is
incorrectly replaced. Replace only with
the same or equivalent type.
6
Insert the holder into the remote
control. The remote control battery
contains Perchlorate Material - special
handling may apply. See www.dtsc.
ca.gov/ hazardouswaste/perchlorate
 
