Advertisement
!
IMPORTANT
Stations can transmit up to 300
feet and between buildings as long
as they are connected to the same
power line transformer.
Ô
Ô
NOTE
Make sure you install the stations
at least 10 feet away from each
other. Placing the stations too
close together produces feedback
and creates a squealing sound.
2
INSTALLATION
You can install the stations almost anywhere there is a
standard AC outlet. Simply plug each station into an outlet
and place it directly on a desk, shelf, table or on a wall.
M
OUNTING
To mount a station on the wall, you need two screws (not
supplied) with heads that fit into the keyhole slots on the
bottom of the stations.
1. Select a location for the station. Mark the mounting
screw locations on the wall 2 inches (50.8 mm) apart,
one above the other.
2. Drill holes at the marked locations.
3. Thread a screw into each hole allowing the screw
heads to extend about
4. Align the keyhole slots on the bottom of the station with
the screw heads in the wall. Slide the station down onto
the screws to secure it.
OPERATION
S
ETTING THE
Each station has two channels, so you can select which
station you want to communicate with. You can also use a
station to monitor sounds near another station.
For example, you could set a station installed in the kitchen
to Channel A and a station installed in the family room to
Channel B. Using the station installed in the kitchen, you
!
can communicate with the station in the family room by
setting the channel selector to B.
Set the channel selector on each station as follows:
• If you want all the stations to communicate with each
other at the same time, set all stations to the same
channel.
• If you want to use a station to communicate with only
one of the other stations, set only those stations to the
same channel.
3
/
inch (4.3 mm) from the wall.
16
C
HANNEL
!
Ô
Advertisement
