Radio Shack 43-3107 Quick Start

™
www.radioshack.com

PREPARATION

1. Remove the doorbell's battery compartment
cover.
2. Insert 4 AA batteries.
3. To change the doorbell
tone, use a flat blade
screwdriver to remove
TONE , and insert it into
the other two pins.
4. Slide CH 1 2 3
same channel as the
indoor intercom.
5. Slide to the desired volume and
VOL 1 2 3
replace the cover.
6. Plug the indoor
intercom into a
standard AC outlet.
7. Mount the doorbell
using the supplied
bracket, anchors,
and screws as
shown.
Q Q
Q Q
UICK UICK
UICK UICK
Indoor/Outdoor Modular

Intercom System

Doorbell Intercom
BELL — Press
to sound the
indoor
intercom.
1 2 3 OUTDOOR
to the
CHANNEL — Set
to the same
channel as the
doorbell
intercom.
Indoor Intercom
TALK — Hold down to
talk over the intercom.
CALL — Press to sound an
alert tone to the other station.
© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.
S S
S S
TART TART
TART TART
Refer to your Owner's Manual for complete instructions.
8. If desired, mount the indoor intercom using
the supplied anchors and screws as shown.
PRESS TO TALK —
Hold down to talk to
the other person.

OPERATION

A B C CHANNEL —
Set multiple
intercoms to the
1. Rotate
same channel to
counterclockwise until it clicks. Then
communicate with
adjust
them.
level.
2. To turn off the indoor intercom, rotate
VOLUME —
VOLUME
Adjusts
volume and
3. Press
powers it on
indoor intercom. Hold down
and off.
DOOR
When you release
TALK TO DOOR —
caller can reply by holding down
Hold down to talk to
TO TALK
the other person.
E E
NGLISH NGLISH
43-3107
VOLUME on the indoor intercom
to the desired listening
VOLUME
clockwise until it clicks.
on the doorbell to sound the
BELL
TALK TO
on the indoor intercom to reply.
TALK TO DOOR , the
PRESS
on the doorbell intercom.