Husqvarna T536LiXP Operator's Manual page 15

To start the product
1. Do a check of the power trigger and power trigger
To do a check of the power trigger
lockout. See
lockout on page 19 .
2. Push the front hand guard forward to engage the
chain brake.
3. Put the battery in the battery holder.
4. Press on the lower part of the battery until you hear
a click sound.
CAUTION: If the battery does not move
into the battery holder easily, it is not
attached correctly into the battery holder.
5. Press and hold the start button until the green LED
light comes on.
488 - 002 - 01.03.2018
WARNING: If you start the product in the
tree, engage the chain brake before you
lower the product onto its strop.
To use the SavE function
This product has a power saving function, SavE. The
SavE function decreases the chain speed and gives the
longest operation time from the battery.
Note: The SavE function does not decrease the cutting
power of the product.
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Press the SavE button again to disconnect the
function. The green LED goes out.
To stop the product
1. Press and hold the start/stop button on the keypad
until the green LED light comes off.
15