Setting The Dialing Mode - Radio Shack TFX-1032 Owner's Manual

43-1204.fm Page 10 Wednesday, August 18, 1999 8:45 AM
• Avoid applying tape to image
areas on copies. The chemicals in
some transparent tape adhesives
could fade the image.
• Avoid storing two copies with the
images together.
image can transfer from one copy
to the other.
• Do not touch the thermal paper
with sweaty or dirty hands.
SETTING THE DIALING
MODE
The TFX-1032 is factory-set to the
tone dialing mode. If your telephone
line uses pulse dialing, you must
change the dialing mode setting. If you
are not sure which type of service you
have, do this test.
1. Lift the handset and listen for a
dial tone.
2. Press any number other than 0.
Note: If your
requires that you dial an access
code (9, for example) before you
dial an outside number, do not
press 0 or the access code.
If the dial tone stops, you have tone
service.
10
If the dial tone continues, you have
pulse service. Follow these steps to
set your fax to the pulse dialing mode.
The printed
phone system
1. Press four times. The fax
MENU
machine displays:
4:SET MODE ?
2. Press , then press
SET
so the fax machine displays:
3:FEATURE SW. ?
3. Press twice so the fax
SET
machine displays:
TONE
4. Press to select the pulse mode.
0 1
The fax machine displays:
10PPS
5. Press to save your selection.
SET
The fax machine displays:
(01)PAUSE TIME
6. Press
STOP/CLEAR
machine displays the date and
time (or
CHECK PAPER ROLL
you have not installed paper).
twice
MENU
(00)
(01)
twice. The fax
if