Appendices: 1 Equipment Required - MC2 Audio E45 Service Manual

Monitor Ch. B output and turn VR1 anti-clockwise until clipping just disappears. Measure
and note the Ch. B O/P power.
Monitor Ch. A output power. Apply the input signal to only Ch. A and adjust VR105 on
PCB701 to match Ch. B in output power.
NOTE THAT POWER MEASUREMENTS OF BOTH CHANNELS TOGETHER CAN
ONLY BE MADE USING A BURST TONE IF A SINE WAVE SOURCE IS USED.
2
CONSULT MC FOR FURTHER INFORMATION IF REQUIRED.
There are no further adjustments but a check of power and frequency response should be made with
reference to the specification in Appendix 2.
9