Frequency Response Curve - Fender Passport PD-500 Owner's Manual

T T R R O O U U B B L L E E S S H H O O O O T T I I N N G G
The POWER LED does NOT illuminate:
Switch the Power OFF, then check the pow-
er connections and retry. If the Power LED
still does NOT illuminate, disconnect all ca-
bles and check the fuse (see FUSE HOLDER
above). If the Power LED still does NOT il-
luminate after 5 seconds, turn off the sys-
tem and take the Passport to an authorized
Fender Service center.
The PROTECT LED illuminates: The system
is in protection mode caused by an overload
or overheating. Switch the Power OFF and
wait for 10 minutes to allow the system to
cool and reset. If the PROTECT LED does not
turn off, take the Passport to an authorized
Fender Service center.
No audio is present in one of the speak-
ers: Check to see if your control settings are
correct. Next, try switching speaker cables
to determine if the cable is at fault.
PD-500 Passport — Speaker

Frequency Response Curve

F e e F e n n e n d d n d e e d e r r e r r P P a a a a s s s s s s
F F P P
® ®
® ®
Part Numbers
Fuse type
Power Requirement
Frequency Response
Distortion
Signal to Noise Ratio
Power Output
Input Impedance
Maximum Input Levels
Woofers
Compression Drivers
Microphones
Microphone Cable
Speaker Cables
Passport System
s s p p p o o p o r r o r t t r t t P D D P D D – – – – 5 5 5 0 0 5
P P
® ®
® ®
S S P P E E C C I I F F I I C C A A T T I I O O N N S S
069-1007-000 (120VAC 60Hz) USA & CAN
069-1007-930 (240VAC 50Hz) AUS
069-1007-940 (230VAC 50Hz) UK
069-1007-950 (220VAC 50Hz) ARG
069-1007-960 (230VAC 50Hz) EUR
069-1007-970 (100VAC 50Hz) JPN
T10A H, 250V
750Watts
20Hz to 20kHz ± 1 dB (Tape, Monitor, Amp Insert)
50Hz to 20kHz ± 1 dB (Speaker output)
< 0.1%, 50Hz to 20kHz (Tape, Monitor, Amp Insert)
< 0.5%, 50Hz to 20kHz (Speaker output)
> 90dB @ 1W, "A" weighted
500W (2x 250W @ 4Ω per channel)
Mic: 2kΩ / Line: 50kΩ (Ch 1-6)
Mic: 2kΩ / Line: 100kΩ / RCA: 47kΩ (Ch 7-8)
Mic: -10dBu / Line: +10dBu (Ch 1-6)
Mic: -4dBu / Line: +16dBu (Ch 7-8)
RCA stereo: +16dBu / RCA mono: +19dBu (Ch 7-8)
8" diameter diaphragm, Neodymium motor structure
1" diameter diaphragm, Neodymium motor structure
Dynamic Cardioid, balanced output
XLR (male) to XLR (female); 6 m (20 ft)
®
Speakon NL2FC; 6.5 m (22 ft)16 AWG stranded copper
Width: 840 mm (33.7 in)
Height: 615 mm (24.2 in)
Depth: 300 mm (11.8 in)
Weight: 24 kg (53 lb)
Note: 0 dBu is referenced to 0.775 volts rms
Product specifications are subject to change without notice.
10
0 0 0 0 0 0