Single And Dual Address Mode - Tanda TX7320 Installation And Operation Manual

Addressable sounder
Table of Contents

Advertisement

3.3 Single and Dual Address Mode

Single address is commonly used to program immediate Evacuate tone while the dual
address used for programming Pre-alarm and Evacuate tones respectively in a given period
of time.
In Single Address Mode
When in action (Evacuation stage), the sounders will produce simultaneously audible signal
according to the pre-defined tone (Table 1- Tone 14 is the default tone) and will stop if the
panel is reset.
In Dual Address Mode
When In action the 1
audible signal according to the pre-defined tone (Table 1- Tone 17 is the default tone). This
will run continuously according to the pre-defined time unless the panel is being reset before.
When the delay time is over the 1
address sounder (Evacuate Stage) will produce simultaneously audible signal according to
the pre-defined tone (Table 1- Tone 14 is the default tone) and will stop if the panel is reset.
1. Attach the programming cable to 1 and 6 Terminals of sounder. Press "Power" to switch-on
the unit.
2. Switch-on the programmer, then press button "3" to enter to Configuration mode (Figure 8).
3. Input the "1" for Single Address mode or "2" for Dual Address mode then press "Write" to
change the setting into the desire mode (Figure 9).
Note: If display "Success", means the entered mode is confirmed. If display "Fail", means
failure to program the mode.
In Dual address mode, the sounder will generate the unique next higher number for the
second address for example: In single address mode the address number is 15, when change
to dual address mode the address numbers will now be 15 and 16.
Warning: Dual address mode may cause Duplicate address fault on the panel and may
affect the operation of the next device with conflicted address number if not carefully
arrange the loop addressing.
1. Read
2. Write
3. R/W Config
4. Set
Figure 8
4. Press "Exit" key to go back Main Menu. Press "Power" to switch off the programmer.
Address sounder (Pre-alarm Stage), will produce simultaneously
st
address sounder will stop then immediately, the 2nd
st
① Single
T
③ Typ
7
⑤Strobe
TX7320 Addressable Sounder
Installation & Operation Manual
②Dual
④Saving
⑥Sound
Figure 9
4050100271-Rev1.0-1215
Specifications are subject to change without prior notice
Configure Description
① Single [Default]
② Dual
TANDA UK
7

Advertisement

Table of Contents
loading

Table of Contents