Read Configuration - Tanda TX7320 Installation And Operation Manual

1. Attach the programming cable to 1 and 6 Terminals of sounder. Press "Power" to switch-on
the unit.
2. Switch-on the programmer, then press button "4" to enter to Setting mode (Figure 14). The
programmer will display the actual configuration after few seconds.
Input the desire Tone (Table 1) then press "Write" to change the setting (Figure 15).
Note: If display "Success", means the entered tone is confirmed (Figure 16). If display "Fail",
means failure to program the tone (Figure16). Tone 14, Tone 16 and Tone 17 are recognized
by LPCB.
3. Press "Exit" key to go back Main Menu. Press "Power" to switch off the programmer.
1. Read
2. Write
3. R/W Config
4. Set
Figure 14

3.7 Read Configuration

1. Attach the programming cable to 1 and 6 terminals of sounder. Press "Power" to switch on
the unit.
2. Switch-on the programmer, then press button "Read" or "1" to enter to Read mode (Figure
17). The programmer will display the configuration after few seconds. (Figure 18).
1. Read
2. Write
3. R/W Config
4. Set
Figure 17
Tone: 001
T
7
Success
Address: 123,124
T
Tone: 008
7
ID: 123456789012
TX7320 Addressable Sounder
Installation & Operation Manual
Figure 15
Figure 18
4050100271-Rev1.0-1215
Specifications are subject to change without prior notice
Tone: 001
Fail
Figure 16
Read Description
Address: Unique number
assigned
Note: Single address displays
one address while dual
addresses display two
addresses
Tone: selected audible tone
ID: Device serial number
TANDA UK
10