Radio Shack ET-685 Owner's Manual page 11

43-685.fm Page 11 Thursday, July 8, 1999 7:50 AM
3. Insert the supplied AC adapter's
barrel plug into the
the back of the base.
4. Route the adapter's cord through
the narrow groove on the bracket. If
you are using two phone cords,
route the second cord through one
of the wide grooves on the bracket.
5. To mount the phone on a wall plate,
plug the other end of the short mod-
ular cord into the wall plate jack,
then align the bracket's keyhole
slots with the wall plate studs and
slide the base downward to secure
it. If you are using two phone cords,
plug the second cord into the sec-
ond phone jack.
jack on
DC IN 9V
To mount the phone directly on a
wall, align the bracket's keyhole
slots with the mounted screws and
slide the base downward to secure
it. Connect the phone cord(s) to the
modular phone line jack(s).
6. Plug the adapter into a standard AC
outlet.
7. Press and lift out the handset
holder, flip it over as shown, then
snap it back into place.
8. Raise the base's antenna to a verti-
cal position.
11