Health O Meter 3001KL-AM User Instructions page 7

ASSEMBLY INSTRUCTIONS
Health o meter® Professional Scales recommends that assembly is performed by
two people.
Warning: Do not drop scale, as this can permanently damage the load cells.
1. Remove the scale platform from the
carton and place scale platform on a
flat, level, and dry surface with the
bottom facing up. Thread the (4) feet
into the underside of the platform. Each
foot should be completely hand
tightened.
2. Turn the platform over so it is facing up.
Locate the handrail and untie the load
cell cable connector. Position the
handrail over the handrail supports on
the platform and feed the cable through
the ring shaped hole located on the right
handrail support.
3. Holding the handrail in place, tip the
platform forward to be able to access
the underside of the platform. Pull the
cable through the ring shaped hole
behind the wheel then feed the cable
through the metal shield as shown.
Feed cable through shield
7
Pull cable through circle Pull cable through hole