AMG AMG9050 series Instruction Manual

AMG9050 series Instruction Manual
5 Port 10/100/1000TX Ethernet Switch with optional PoE
The AMG905 is a rack mountable or standalone unmanaged Ethernet switch providing 5 standard
RJ45 ports with up to 1Gb speed supported on each port. Ports 1 to 4 can also provide Power over
Ethernet in compliance with the IEE 802.3af or IEE 802.3at standard (depending on power supply
variant)

Before You Begin

Read these instructions carefully before installing or operating this product.
Note: This equipment should be installed by a qualified service person and should conform to local
and national regulations.
This manual provides installation and operation information. To use this document you must have the
following minimum qualifications:

A basic knowledge of IP networks and configuration.

A basic knowledge of electrical wiring and low-voltage electrical connections.

Intended Use

Use this product only for the purpose for which it was designed, as described in this manual.
WARNING:
Improper use or deployment of this equipment could cause severe bodily
injury or equipment damage
Manufacturer's Declaration of Conformance
A Declaration of Conformity in accordance with the following EU standards has been made
and is kept on file at the address shown on the last page.
The manufacturer declares that the product supplied with this document is compliant
with the provisions of the EMC Directive 89/336, the Low Voltage Directive LVD 73/23,
the CE Marking Directive 93/68 EEC and all associated amendments.
AMG Systems Ltd. reserves the right to make changes to this
document without prior notice. The information herein is believed to
be accurate. No responsibility is assumed by AMG Systems for its use.
AMG9050 Series Instruction Sheet D18914-02
Page 1