Radio Shack ET-536 Owner's Manual page 17

43-1036.fm Page 17 Tuesday, August 17, 1999 9:52 AM
Problem
Handset does not ring or
receive a page.
The handset stops working or
works poorly during a call.
The call is too noisy.
If you still have problems, disconnect the phone. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance
Suggestion
• The battery pack might be weak. Charge
the battery.
• Extend the base's antenna vertically.
• Move the handset closer to the base.
• Move the base away from other electrical
devices and sources of noise.
• Move the handset closer to the base.
• Fully extend the base's antenna, and place
it in a vertical position.
• Make sure the charging contacts on the
handset and base are clean.
• Be sure the handset's battery is charged.
(If the battery power is too low, it does not
have enough power to light the BATT LOW
indicator.)
• If the base loses power while the handset
is off of it, the security access-protection
code might change. Restore power to the
base, then place the handset back on the
base. The CHARGE indicator lights, indi-
cating that the code is set again.
Change channels or hang up and redial the
number.
17