Fault Handling; Before Use - WDH -220B User Manual

earlier according to actual operating environment.
ATTENTION:
Please turn power off and pull out power plug before replacing the filter net.
6. Fault handling
This chapter lists out possible faults when using this product. If faults could not be
resolved by using the following information, please contact TCL customer service
center or the distributor.
Status Possible reason
Front panel is not installed
properly.
Power plug is not inserted.
The machine
Power plug or electric wire
cannot
is damaged.
start and
Performance of the filter
operate.
net is exhausted without
changing. The
stops running.
Possible solution
Dismantle the front panel, and reinstall
the front panel.
Pull the power plug out and insert it
again.
Contact customer service center or the
distributor.
Please refer to instructions and change
filter net.
machine
37
The machine is not turned
on.
Electric motor is damaged.
The machine is put on
The fan does uneven surface.
not work. Loose or foreign particles
are inside the machine.
Electric motor is loose.
Did not remove plastic
packing of each filter net.
Wind speed Night mode is automatically
cannot be started. LED light of the
adjusted machine is off. Meanwhile,
automatically wind speed and noise level
when auto are reduced.
mode is
activated.
Washable filter net is dirty.
Filter nets are not changed.
Insert the power plug and restart the
machine.
Contact customer service center or the
distributor.
Move the machine to a flat and stable
surface.
Contact customer service center or the
distributor.
Contact customer service center or the
distributor.
Remove plastic packing of each filter
net before use.
Continuously press wind speed button
to choose a favorable wind speed.
Wash the washable filter net.
Change a new set of filter nets.
38