Selecting The Message Record Time - Radio Shack 43-3827 Owner's Manual

Ô Ô
NOTE
After setting the Announce
only feature, you may want
to change the prerecorded
outgoing message to that of
Announce Only. However, it
changes automatically.
32

Selecting the message record time

You have three record time options. The options "
minute" or " minutes" set the duration for recording
4
the incoming messages. "
the call with the preset greeting or your personal
greeting but prevents the caller from leaving a
message.
1. Press four times in standby mode.
MENU
You hear "Record time" and the current
recording time ([ ] 1 minute, [ ] 4 minutes, [ ]
Announce only, No recording), and it is
displayed on the base. Then you hear the
guidance for setting the record time.
2. Press
VOL/SEL/
desired time appears.
3. Press
SET/RING
time. You hear a confirmation tone, then the
announcement "Record time" and new
recording time is announced. After a few
seconds, the system announces "To set
message alert, press menu again".
$ $ $ $
Announce only feature
The announce only feature plays a prerecorded
outgoing message "Hello, no one is available to
take your call. Please call again.", and it will not
allow the caller to leave a message. To set
"Announce only", follow the steps above. Ô
To scroll between the prerecorded message or your
own personal greeting, press
outgoing message is played. If you want to use your
own greeting, or want to change your greeting, refer
to "Recording a personal outgoing message"
(Greeting) on page 34.
Announce only
# or $ until the
VOL/SEL/
to select the new recording
when the
OGM
1
" answers