Radio Shack 43-3856 Owner's Manual page 10

!
IMPORTANT
Be sure the battery pack is
properly connected before
you try to charge it. The
indicator
CHARGE/IN USE
lights when the handset is
on the base even if the
battery pack is not
connected properly.
Ô Ô
NOTE
• If the phone does not
work, recharge the
battery pack. (The
battery power might be
too low for the display to
operate.)
• If the battery pack
becomes weak during a
call, the handset beeps
and
TALK/BATT LOW
LED flashes. When this
happens, you cannot
make a call on the
phone until you recharge
the battery pack.
• If the battery pack is
completely discharged
or the base loses power
while the handset is
away from it, place the
handset on the base to
change the security
access-protection code.
If it was the handset that
lost power, recharge the
battery pack.
10
3. Plug the battery
pack's connector into
the socket in the
compartment. The
!
connector fits only
one way.
4. Put the battery pack
in the compartment.
5. Replace the cover.
To charge the battery pack, place the handset on
the base, face up or down. The base's
indicator lights.
USE
Recharge the battery pack when
LED flashes.Ô
When you first use the phone after charging or
recharging the battery pack, the phone might not
work and you might hear error beeps. If this
happens, while holding
the base for about 5 seconds to change the security
access-protection code.
Using a pencil eraser, clean the charging contacts
on the handset and the base about once a month.
About once a month, fully discharge the battery
pack by keeping the handset off the base until
TALK/BATT LOW
battery pack loses its ability to fully recharge.
!
TALK/BATT LOW
, place the handset to
find hs
LED flashes. Otherwise, the
CHARGE/IN