Table of Contents
Advertisement
On a Desk Top
1. Plug one end of
the supplied long
modular cord into
the
TEL LINE
on the back of the
base.
2. Plug the modular
cord's other end
into a modular
phone line jack.
3. Insert the supplied
AC adapter's
barrel plug into the
back of the base.
4. Route the adapter's cord through the
strain relief slot on the base, then plug
the adapter into a standard AC outlet.
5. Lift the base's antenna to a vertical
position.
On a Wall Plate or Wall
To mount the phone directly on a wall, you
need two screws (not supplied) with heads
that fit into the keyhole slots on the base.
15
Drill two holes 3
screw into each hole, letting the heads
1
extend about
/
inch.
8
1. Detach the bracket from the bottom of
the base.
2. Insert the two
tabs at the top of
the narrow end of
the supplied
bracket into the
base's upper tab
slots, then press
down on the
bracket's latches
and insert them
into the lower slots.
TEL
DC IN 9V
LINE
jack
jack on the
DC IN 9V
/
inches apart. Thread a
16
CAUTION
You must use
!
a Class 2
power source
that supplies 9V DC and
delivers at least 350 mA.
Its center tip must be set
to positive and its plug
must fit the phone's DC
IN 9V jack. The supplied
adapter meets these
specifications. Using an
adapter that does not
meet these
specifications could
damage the phone or
the adapter.
9
Advertisement
Table of Contents
