Table of Contents
Advertisement
1. Plug one end of the supplied
modular cord into the
jack on the bottom of the base.
2. Insert the supplied AC adapter's
barrel plug into the
on the bottom of the base and
route the adapter's cord through
the strain relief slot on the base.
3. Route the modular cords through
the molded routing channels on
the back of the base as shown
here.
4. For a wall plate or direct wall
mounting, align the base's
keyhole slots with the wall plate
studs or mounting screws and slide the base down to
secure it.
5. Plug the other end of the modular cord into a modular
phone line jack.
6. Plug the adapter into a standard AC outlet.
7. Lift the base's antenna to a vertical position.
C
ONNECTING AND
P
ACK
The phone comes with a rechargeable nickel-cadmium
battery pack in the handset, but not connected. Before
using your phone, you must connect the battery pack, then
charge it for about 15–20 hours.
1. Press down and slide off the battery compartment
cover to remove it.
2. Lift the battery pack out of the compartment.
3. Plug the battery pack's connector into the socket in the
compartment (the connector fits only one way), then
place the battery pack in the compartment.
4. Replace the cover.
To charge the battery pack, place the handset on the base
with the keypad facing forward. The CHARGE/IN USE
indicator on the base lights. Recharge the battery pack
when the handset beeps during talk and TALK/BATT LOW
o
flashes.
Recharging the Battery Pack
• If the CHARGE/IN USE indicator does not light when
you place the handset on the base, be sure the battery
pack and AC adapter are correctly and securely con-
nected. Also, check the charging contacts on the hand-
set and the base. If the contacts are dirty or tarnished,
clean them with a pencil eraser.
TEL LINE
" " " "
jack
DC IN 9V
DC IN 9V
C
HARGING THE
!
mA. Its center tip must be set to
positive and its plug must fit the
phone's DC IN 9V jack. The
supplied adapter meets these
specifications. Using an adapter
that does not meet these
specifications could damage
TEL
the phone or the adapter.
LINE
• Always connect the AC adapter
to the phone before you connect
it to AC power. When you finish,
disconnect the adapter from AC
power before you disconnect it
from the phone.
The EPA certified
RBRC
Recycling Seal on the
B
ATTERY
nickel-cadmium (Ni-
Cd) battery indicates
RadioShack is
voluntarily participating in an
industry program to collect and
recycle these batteries at the end of
their useful life, when taken out of
service in the United States or
Canada. The RBRC program
provides a convenient alternative to
placing used Ni-Cd batteries into
the trash or the municipal waste
stream, which may be illegal in your
area. Please call 1-800-THE-
SHACK (1-800-843-7422) for
information on Ni-Cd battery
recycling and disposal bans/
restrictions in your area.
RadioShack's involvement in this
program is part of the company's
commitment to preserving our
environment and conserving our
natural resources.
Dispose of the old battery pack
promptly and properly. Do not
burn or bury it. See "Battery
Safety Instructions" for additional
information on proper battery
handling.
"
"
CAUTION
You must use a Class
!
2 power source that
supplies 9V DC and
delivers at least 210
!
!
IMPORTANT
®
Battery
o
o
WARNING
5
Advertisement
Table of Contents
