Advertisement
To change for left ear wearing, use the instructions as
follows:
1. Open the headset boom arm.
2. Put the headset's earhook in its opened position.
3. Gently lift and pull the top of the earhook up from
the upper hinge pin and pull away to remove [A].
4. Turn the headset over [B].
5. Hook the bottom of the earhook on to the lower
hinge pin and lift and pull the top of the earhook
over the upper hinge pin [C].
The volume + (up) or volume – (down) buttons will
re-orient automatically.
Placing the headset on your ear [A]
In order to wear the headset follow these instructions:
1. Open the headset boom arm.
2. Put the earhook in its opened position
(90° away from the headset).
3. Loop the earhook behind your ear.
4. Close the headset boom arm towards your ear.
The headset boom arm will then point towards your
mouth.
4.3 Setting up your GN 1000 RHL (accessory)
The GN 6110 can be connected to GN Netcom's GN 1000 Remote Handset Lifter (acces-
sory). This gives you the additional convenience of answering and ending calls even
while away from your desk.
16
GN6110_contents_EU_21-10-03.indd 16-17
A
To connect your GN 1000 to the GN 6110, complete the following:
1. Connect the GN 1000's connector cord to the yellow-
marked hook switch [AUX] socket on the bottom of the
base [A].
2. Consult the GN 1000 user guide to complete the set up.
B
Note: If you cannot locate the GN 1000 product box
and/or user guide, consult GN Netcom's web pages at
www.gnnetcom.dk.
Your GN 6110 is now ready to use with your GN 1000, and you may proceed to Section 4.4.
C
4.4 Setting up your GN 1000 RHL (accessory)
Turning headset ON:
Open the headset boom arm. The headset indicator will light for 2 seconds, and then
continue to fl ash slowly as long as the headset is on.
Turning headset OFF:
Close the headset boom arm. The headset indicator will light for 2 seconds, after which
it will turn off.
Making calls:
1. With the boom arm open, press
the Multifunction Button on either
the headset [C] or the base [B].
An audible tone will be heard and
the connection will be established
shortly.
A
C
A
B
23-10-2003, 09:39:24
17
Advertisement
