1.2 Parts and signatures 2. Assembling your GN 6110 To fully benefi t from your GN 6110, follow the instructions in this user guide step by 2.1 Setting up for desk telephone use step.
1.2 GN 6110 – Parts and signatures 2. Assembling your GN 6110 First assemble your GN 6110 to work with your desk telephone, and then set it up to work with your mobile phone. The GN 6110 supports the GN 1000 Remote Handset Lifter for desk telephones as well as newer telephones with built-in electronic hook switches.
Page 4
Clear dial tone adjustment base’s right or left slot, depending if your desk telephone is positioned to the right Desk telephones operate on a range of standards. In order for your GN 6110 to work or left of the base.
Page 5
4-digit passkey code: 0000. The mobile phone will now begin pairing and store your GN 6110 headset in its 2.2 Setting up for mobile telephone use memory. Your mobile phone screen will advise that pairing has been successful.
Page 6
Making calls: Headset handset switching (while on a call). 1. With the boom arm open, press the Multifunction Button on either To switch from using the headset to the the headset [C] or the base [B]. handset during a call: An audible tone will be heard and 1.
Page 7
3.2 Operation – with mobile telephone 3. Give the desired voice command. If your headset is in its base, press the release headset button to free the headset before using it. The headset indicator will fl ash rapidly for the duration of the call. Turning headset ON: Answering calls: 1.
Page 8
+ (up) and the lower button is always 4.2 Wearing and wearing styles volume – (down). Choosing right or left ear wearing styles The GN 6110’s headset comes confi gured for wearing on your right ear. GN6110_contents_EU_21-10-03.indd 14-15 23-10-2003, 09:39:24...
Page 9
5. Hook the bottom of the earhook on to the lower hinge pin and lift and pull the top of the earhook Your GN 6110 is now ready to use with your GN 1000, and you may proceed to Section 4.4. over the upper hinge pin [C].
Your call is now terminated. 2. You may continue wearing your headset, or replace the (closed) headset boom arm With an initial full battery charge and continual daily charging, the GN 6110’s battery will in the base for charging.
Page 11
Pairing your headset set from its base. In order for your GN 6110 to work correctly, the headset and the base must be paired together. For your convenience, these two devices in their original product box have During initial (and subsequent) charging, you may use your desk tele- been factory-paired.
1. With the boom arm open, press the Multifunction Button on either The GN 6110’s headset and base have audio and visual indicators, which represent the headset [C] or the base [B]. various actions and aspects associated with setting up and operating the product.
Should I unplug my telephone’s line cord from the wall? Closed boom arm (turn OFF) Lights for two secons No, do not unplug your telephone’s line cord from the wall. Your GN 6110 is not a Test link established Flashes twice telephone, but rather works with your desk telephone.
Once you have a clear dial tone, your GN The plastic bags the GN 6110 and its parts are wrapped in are not toys for children. The 6110 is correctly adjusted.
Page 15
Only authorised dealers or service centres may open the product. If any parts of FCC Notice to Users/Product Statements your GN 6110 require replacement for any reason, including normal wear and tear or This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, breakage, contact your dealer.
Page 16
GN Netcom Inc. 77 Northeastern Blvd. Nashua NH 03062 Canada IC Notice to Users/Product Statements Operation is subject to the following two conditions: (1) This device may not cause interference and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Need help?
Do you have a question about the GN 6110 and is the answer not in the manual?
Questions and answers