Sharp SJ-FSD910 Operation Manuals page 21

Water dispenser
Cleaning the dispenser tank
Remove the dispenser tank approximately once a month
and wash it with water.
1
Empty the dispenser tank.
Push the lever and let out all water in the dispenser tank.
2
Remove the dispenser tank from the door.
Take the both latches off .
1�
Lift the dispenser tank up to remove.
2�
1
Dispenser tank
2
3
Disassemble the dispenser tank.
Remove the cap.
1�
Remove the cover. (Latches : 5 pieces)
2�
Remove the tank pipe and the tank nozzle.
3�
Disassemble the tank nozzle.
4�
2 2
2 2
1
4
Latch
1
2 2
Cover
Cap
2
2
Latch
Packing
Tank pipe
3
Tank nozzle
3
After cleaning
1
Assemble the dispenser tank.
(Reverse procedure to disassemble.)
Ensure that each parts are attached fi rmly. Otherwise
it may cause water leakage.
2
Install the dispenser tank.
Insert the dispenser tank fully and make sure to fasten
the latches to install.
Dispenser tank
3
3
2
1
2
Protrusions of
the door
3
Note
• When humidity is high, dew condensation may occur on
tank pipe and tank nozzle.
• Make sure not to lose the packing when you
disassemble the tank.
2
Hook of the dispenser
tank
Put the hook on
the protrusion of
the door.
Latch
Tilt the latch
back.
21