Portable Movement Detectors; Dual-Action Infrared/Radio Transmitters; Configurator For Dual-Action Infrared/Radio Transmitters - C-TEC QT606A Manual

PORTABLE MOVEMENT DETECTORS

A simple to operate adjustable weight sensor which sits under the
leg of a bed and connects to a call point's remote socket via a
jack plug. A call is triggered when the bed is vacated, thus
alerting staff to the prospect of a wandering patient.
NC805MD ............ Portable Movement Detector

DUAL-ACTION INFRARED/RADIO TRANSMITTERS

Quantec's new QT412 range of rechargeable dual-action
infrared/radio transmitters have a typical infrared
transmitting range of 10m (line of sight) and a typical
radio transmitting range of around 60m.
Each transmitter has two infrared emitters (one on each side to maximise performance), two
buttons (A & B) and a retained 'pull clip'. Depending on its configuration, pressing a
transmitter's buttons or activating its 'pull clip' will generate a standard, help required,
emergency or staff attack call on a compatible Quantec infrared and/or radio receiver.
Housed in a tough plastic enclosure, each transmitter provides battery low indication as
standard and can be recharged fully in approximately 14 hours using the QT424/1 single way
charging unit. A ten way charging unit, the QT424/10, is also available for sites with multiple
transmitters.
Two pre-configured transmitters are available, the QT412RXA push for attack/pull for attack
transmitter and the QT412RXCA push for call/pull for attack transmitter. If a different
transmitter configuration is required, the QT423 configurator (described below) will allow an
engineer to reprogram any of the above transmitters to suit the operational requirements of
an individual site.
QT412RXA ........... Dual action infrared/radio transmitter (configured for push for attack/pull for attack)
QT412RXCA ......... Dual action infrared/radio transmitter (configured for push for call/pull for attack)
QT424/1 ............... Single way battery charging unit for QT412 range transmitters
QT424/10 ............. Ten way battery charging unit for QT412 range transmitters
CONFIGURATOR FOR QT412 RANGE DUAL-ACTION TRANSMITTERS
The QT423 configurator allows the operation of any QT412 range transmitter
to be tailored to suit the requirements of a specific site. In particular it allows
authorised engineers to :-
• Assign the level of call that will be triggered when the transmitter's A button is pressed.
• Assign the level of call that will be triggered when the transmitter's B button is pressed.
• Assign the level of call that will be triggered when the transmitter's 'pull clip' is activated.
• Set the transmitter's A & B buttons so they only trigger a call when both are pressed simultaneously.
• Turn the transmitter's on-board 'confidence' beeper on or off.
• Turn the transmitter's radio action off.
• Set the transmitter's transmission time to run continuously or to automatically switch off after a
pre-determined time .
• Assign the transmitter an RF group ID address (1 to 16) to match the setup of any Quantec radio
receivers on the system - see RADIO RECEIVERS, page 7, for further details.
• Change the transmitter's mode of infrared transmission to 'pulsed' to suit older Quantec systems.
Each configurator comes with a programming CD (Windows 2000/XP compatible), a USB
connection lead (to connect the configurator to a PC) and a lead for connecting the
configurator to a QT412 range transmitter for programming.
QT423 .................. Quantec Configurator
Approved Document No: DNSQ100101 Rev 6 • Page 10 of 16
Configurator
USB
Device