rear co er KIT CONTENTS: instructions front cover rudder fuselage wing panels (left/right) elevator (left/right) lower cover Canopy Bowden 1pcs tai skid elevator link Vheels 2 ps motor mount gear holder wood screwt 2,2x9,5 steel wire of wheels horns 4 ps snaps for regulacion of pushrods rubber loop 4 ps...
Page 3
Receiver Battery Elevator servo - left side Gear holder Ailerons servo Rudder servo - right side Make holes for battery, receiver and servos in the fuselage (use soldering iron and/or knife) The eguipment must tightly fit in the holes without unnecessary clearance. Make slots/ducts for servo wires.
Page 4
Mount the pushrods trought tubes to the rudder Glue the rear cover to the fuselage with PU. and servo horns, adjust the proper lenght of Cut the front cover to the three parts and their outside pushrod to bring the control surfaces into the glue to the fuselage with PU.
Page 5
Completion: Mount the engine to the motor mount 19. Try a center of gravidity of model and fixing battery to the fuselage with velcro or rubber loop. 80-90 Fix the rmovable with a rubber loop Wiring diagram (an example) 10-15 10-15 Other planes of our EPP series are on the webside www.boruvka.info Page 6...