Kit content: 6 rudder 3 Rear cover 5fin 4 Canopy 7 reinforcement of fin 9 elevator Upper cowl (cover) 8 stabilizer 2 wing left/right 10 reinforcement of stabilizer 1 Fuselage 11 reinforcement of wing horns 4 pcs. wheels landing gear 3 pcs 1 pc Bowden...
Page 3
Glue wood reinforcement (beam) to the left panel. Use PU glue. Join and glue the left panel with the right one use PU glue 30 mm 30 mm desk Glue the whole wing to the fuselage (use Pu glue). Check the correct position. Glue the reinforcement [part 10] to the stabilizer 8.
Page 4
Cut the upper cover (cowl) according to the picture. The pushrod tubes should remain straight - so the slots must be The middle part is removable and enables easy access cut properly. Bend one end of the pushrod to "Z" shape. Mount the to battery which located inside.
Page 5
70 - 80 mm BATT Make hole the receiver in the fuselage use soldering iron and/or a knife Balance the model with the battery - cut the hole so that the balance point center of gravity ) position i s according to the picture. Wiring diagram example Page 5...