Setting Time In Standby Mode; Automatic Power Off Function; Selecting Modes; Adjust The Speaker Level Settings And Effects - JVC TH-W513B Instruction Manual

Setting Time in Standby mode

In STANDBY mode, the display will show "--:--", and then "PRESS AND HOLD PAIR BUTTON TO
SET TIME". Press and hold
1. Press VOL+/VOL– Button on the unit or remote control to set the hours, then press
PAIR on the unit or remote control to confirm.
2. Press VOL+/VOL– Button on the unit or remote control to set the minutes, then
on the unit or remote control to confirm.
3. The time is now set. When you switch the unit to STANDBY mode, the unit will show
STANDBY and then the time clock.

Automatic Power Off Function

The unit automatically turns to STANDBY mode after 15 minutes if the TV or the external unit is
disconnected or switched off in OPTICAL mode or the volume is too close to mute in COAXIAL,
AUX, LINE IN and BT mode.
• To switch the unit off completely, remove the mains plug from the mains socket.
• Please turn the unit off completely to save energy when not in use.

Selecting Modes

Press SOURCE repeatedly on the main unit or remote control to switch between BT, Optical,
Coaxial, AUX and LINE IN mode.

Adjust the Speaker Level Settings and Effects

Adjusting Volume
• Press VOL+/VOL– on the unit or remote control to adjust the volume.
If you wish to turn the sound off, press MUTE. The display will show "MUTE". Press MUTE
•
again, or press VOL+/VOL– to resume normal listening.
Select Equaliser (EQ) Effect
Press the EQ button on the unit or the CUSTOM/MOVIE/MUSIC button on the remote control
to select the preset equaliser effects (CUSTOM/MOVIE/MUSIC).
• While the unit is in COAXIAL, OPTICAL, or AUDIO IN mode, it will automatically switch into MOVIE
EQ effect.
• While the unit is in Bluetooth mode, it will automatically switch into MUSIC EQ effect.
Adjusting the Bass/Treble Level in CUSTOM EQ mode
1. Press EQ button on the unit repeatedly, or press CUSTOM button on the remote control to
select default EQ mode.
2. Press BASS/TREBLE on the remote control. The display will show the current BASS/TREB
level.
3. Press VOL+/VOL– on the unit or remote control to adjust the bass/treble level (–03 to +03).
The unit will exit from BASS/TREBLE setup after idle for about 5 seconds.
/ PAIR on the unit or remote control to set the time.
/
/ PAIR
15