If You Suspect Something Wrong - Panasonic CR-SM4208U Operating Instructions Manual

If you suspect something wrong

Check and take steps as described below.
If the described suggestions do not solve the prob-
lem, it is recommended to take the unit to your
dealership. The product should be serviced only by
repair to professionals. We shall not be liable for any
accidents arising out of neglect of checking the unit
or your own repair after your checking.
Never take measures especially for those other than
indicated by italic letters in "Possible Solution"
described below because those are too dangerous
for users to handle themselves.
Common
Problem
No power to the unit
Sound is not generated.
Noise
Noise is made in step with engine
revolutions.
Some operations are not
executable.
No sound from speaker(s)
40
Do not use the unit in an irregular condition, for
example, without sound, or with smoke or a foul
smell, which can cause ignition or electric shock.
Immediately stop using the unit and consult your
dealership.
Never try to repair the unit by yourself because it
is dangerous to do so.
Possible cause
The power cord (battery, power and ground) is connected in the
wrong way.
Check the wiring.
Volume is set to zero (0).
Adjust volume.
There is contact between the external mute lead and the chassis.
Connect the external mute lead correctly. If the lead is
unused, insulate it.
The wiring of speaker lines are not correct, or a break or poor
contact arises.
Check the wiring in accordance with the wiring diagram.
There is an electromagnetic-wave generator such as a mobile
phone near the unit or its electrical lines.
Keep an electromagnetic-wave generator such as a mobile
phone away from the unit and the wiring of the unit. In case
that noise cannot be eliminated due to the wiring harness of
the vehicle, consult your dealership.
The contact of the ground lead is poor.
Make sure that the ground lead is connected to an unpainted
part of the chassis securely.
Alternator noise comes from the vehicle.
Change the wiring position of the ground lead.
Some operations are not executable in particular modes such as menu
mode.
Read the operating instructions carefully and cancel the
mode. If the unit is still out of order, consult your dealership.
BALANCE/FADER setting is not appropriate.
Readjust BALANCE/FADER.
There is a break, a short circuit, poor contact or wrong wiring
regarding the speaker wiring.
Check the speaker wiring.
Warning
Possible solution