PreCise Biometrics Precise 100 Quick Reference page 2

Installation
Connect the fingerprint reader
If you have a Precise 100 Reader with USB connector, skip this sectionand go to the next
page "Log on as an administrator". If you have a Precise 100 Reader with parallel port
connector, follow the instructions below.
1. Make sure that the computer has been turned off.
2. Connect the fingerprint reader to the computer as shown below.
parallel port connector
NOTE: The parallel port must be set to ECP
mode, otherwise the fingerprint reader will not
pass-through
PS/2 connector
function properly. Please refer to the computer
keyboard
PS/2 connector
manual for additional information, or follow the
instructions below.
To set the parallel port:
1. Access the system setup utility on your computer. On most computers this is done
by pressing the F1, F10, Delete or Esc key during system booting, i.e. immediately
after switching on the computer.
2. Find the parallel port mode and set it for ECP. If the ECP selection is unavailable,
the parallel port is probably already set for ECP.
3. Save your changes and exit the system setup utility.
Log on as an administrator
You must have administrator rights on your local computer to install the
Precise 100 Client software.
Install software
Insert the Precise 100 Client software CD. The Master Setup screen will appear.
1. If you have a Precise 100 Reader with USB connector, please connect it to your PC
now. Windows 2000 will detect the new hardware and install the necessary drivers
from the CD. If you have a Precise 100 Reader with parallel port connector, click the
Parallel Driver button to install the necessary parallel port drivers.
2. If you are using Windows NT you must install the Microsoft Smartcard Base
Components, if not previously installed.
install the Smartcard Base Components, the system may crash
NOTE: If the CD does not start automatically, start
the CD from the desktop by double-clicking My
Computer > CD > MasterSetup.exe icon.
If you are using Windows 2000 do not
.