Mounting Locations - Motorola FX5000 User Manual

FX5000.book Pages 10 - 11 Monday, February 14, 2000 1:24 PM
Installation

Mounting Locations

Overview
Your FX5000 Digital telephone has been designed for use on a horizontal surface (like a desk) or
a vertical surface (mounted to a wall). Both mounting methods are described below.
Desktop Mounting
You may place your phone on any horizontal
surface, such as a desktop or counter top. Be sure
to position your phone so that the DC power cord
will reach a nearby electrical outlet. Note that the
antenna should be positioned vertically as shown
at right.
10
Wall Mounting
You may mount your phone on any vertical surface, such as a
wall. Be sure to position your phone so that the DC power
cord will reach a nearby electrical outlet. Note that the
antenna should be positioned vertically as shown. Install two
3 mm or 1/8" screws (not supplied) per template and adjust
them until the phone has been firmly attached to the wall.
NOTE Before drilling holes to wall mount your phone, it is a
good idea to plug in your phone (described in "Plugging into
AC Power" on page 12) and verify that you are receiving a
strong signal (as indicated by the LED on the base turning
green) and you are able to place and receive calls.
Route the DC power cord to
Route the DC power cord to the
the back of the base and
back of the base and thread it
thread it through the cable
through the cable retaining track
retaining track as shown.
as shown. The DC power cord
The DC power cord should
should hang down from the bot -
hang down from the bottom
tom of the base.
of the base.
Installation
8.3 cm
(3 1/4 ")
Install two screws (not supplied)
Attach phone as shown.
per template, then attach phone
as shown.
11