Page 1
WIRING Figure 2a TMPR Wiring for a N.C. loop, no TMPR EOL resistor LATCH Be sure to test the FG-1025 for detection in the final Figure 2b mounting location. Wiring for a TMPR N.O. loop, no Tip: EOL resistor TMPR...
Page 2
Breakout Tab (9.78 mm) #8 or #10 Screw NOTE: (M 4 or M 5) Rear Housing Install screw to seat in tamper cavity FG-1025 CONFIGURATION LATCH Figure 3 Figure 3 Figure 3 Figure 3 Figure 3 Press down on this latch to...
Page 3
TESTING IMPORTANT: LED Indicators: Condition Green LED Red LED Figure 6 APPLICATIONS INFORMATION NOTE: To test the FG-1025: To minimize the chance of false alarms: To maximize detection: IMPORTANT: NOTE: SELF-TESTS Figure 7...
Page 4
Tamper Switch: Dimensions: Weight: Power Requirements: Approvals/Listings: Accessories: Note: Note: Note: FCC Notice: IC Notice: IntelliSense is a registered trademark of Honeywell, Inc. Copyright 2001 IntelliSense. Other trademarks are the property of their respective owners. All rights reserved. 5-051-411-00 Rev C...