Toro Groundsmaster 4000 Operator's Manual page 21

Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Engine Run
Glowplugs
Fan
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Protected Menus
Auto Idle
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine and
fan have been on, as well as
the number of hours that the
machine has been transported
and overheated
Lists the number of preheats
and starts that the machine
has experienced
Description
Refer to the Service
Manual or your Authorized
Toro Distributor for more
information on the Engine
Run menu and the information
contained there.
Indicates if the following items
are active: Key start, timeout
limited, and glowplugs
Indicates if the fan is active
in the following instances:
Engine high temp, oil high
temp, engine or hydraulic high
temp, and fan on
Description
Controls the units used on the
InfoCenter; the menu choices
are English or Metric
Controls the language used
on the InfoCenter*
Controls the brightness of the
LCD display
Controls the contrast of the
LCD display
Allows a person authorized
by your company with the
PIN code to access protected
menus.
Controls the amount of time
allowed before idling the
engine when the machine is
not in use
Mow Speed
Trans Speed
Smart Power
*Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced."
Titles will be in the selected language, but menu items
are in English.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 4 operating configuration settings that are
adjustable within the Settings Menu of the InfoCenter:
auto idle time delay, maximum mowing ground speed,
maximum transport ground speed, and Smart Power.
These settings are in the Protected Menu.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the
code, contact your Authorized Toro Distributor for
assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
21
Controls the maximum speed
while in mow (low range)
Controls the maximum speed
while in transport (high range)
Smart Power prevents
bogging down in heavy turf by
automatically controlling the
machine speed and optimizing
cutting performance.
Description
Lists the model number of the
machine
Lists the serial number of the
machine
Lists the software revision of
the master controller
Lists the software revision of
the InfoCenter
Lists the machine
communication bus status
M , use the center button to
ENU
M and press the
ETTINGS ENU
10).