Filling The Fuel Tank; Checking The Engine-Oil Level; Breaking In A New Machine; Think Safety First - Toro TimeCutter 74780 Operator's Manual

Important: Do not use fuel additives containing
methanol or ethanol.
Add the correct amount of fuel stabilizer/conditioner
to the fuel.
Note: A fuel stabilizer/conditioner is most effective
when mixed with fresh fuel. To minimize the chance of
varnish deposits in the fuel system, use fuel stabilizer at
all times.

Filling the Fuel Tank

1. Park the machine on level ground.
2. Shut off the engine and engage the parking brake.
3. Clean around the fuel-tank cap.
4. Fill the fuel tank to the bottom of the filler neck
7).
Note: Do not fill the fuel tank completely full. The
empty space in the tank allows the fuel to expand.
B
A
D
E

Checking the Engine-Oil Level

Before you start the engine and use the machine, check
the oil level in the engine crankcase; refer to
Engine-Oil Level (page 28).
C
g027243
Figure 7
Checking the

Breaking in a New Machine

New engines take time to develop full power. Mower decks
and drive systems have higher friction when new, placing
additional load on the engine. Allow 40 to 50 hours of
break-in time for new machines to develop full power and
best performance.

Think Safety First

Please read all safety instructions and symbols in the safety
section. Knowing this information could help you or
bystanders avoid injury.
DANGER
Operating the machine on wet grass or steep slopes
(Figure
can cause sliding and loss of control.
• Do not operate on slopes greater than 15 degrees.
• Reduce speed and use extreme caution on
slopes.
• Do not operate the machine near water.
DANGER
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death, or
drowning.
Do not operate the machine near drop-offs.
DANGER
Operating the machine while the roll bar is down
may lead to serious injury or death in the event of a
rollover.
Always keep the roll bar in the fully raised and
locked position and use the seat belt.
g027243
13