Mower Storage - Jacobsen Zero Turn Rotary Mower Safety, Operation & Maintenance Manual

9.21 MOWER STORAGE ________________________________________________________

General
• Clean the mower and lubricate. Repair and paint damaged or open metal.
• Inspect the mower, tighten all hardware, replace worn or damaged components.
• Clean the tires and keep the mower so that the load is not on the tires. If the mower is not on the jack stands,
check tires at normal intervals and add air when needed.
• Keep the mower and all accessories clean, dry and protected from the elements. Never keep the mower near an
open flame or spark which can cause ignition of the fuel or fuel vapors.
Battery
• Remove, clean and keep the battery in the upright position on a surface that is not metal in a cool dry location. To
prevent increased battery discharge, do not keep the battery on a metal surface.
• Check and charge the battery every 60 to 90 days.
• Keep the battery in a cool dry location. To decrease the self discharge rate, the temperature must not be more
than 80° F (27° C) or less than 20° F (-7° C).
Engine
• Change the engine oil and filter.
• Clean the outside surface of the engine. Paint bare metal or apply a thin layer of rust preventative oil.
• Add a fuel stabilizer to prevent the fuel to become stale. See your fuel supplier for instructions. Start the engine.
Operate the engine for two minutes to circulate the stabilizer throughout the fuel system.
Cutting Units
• Completely clean the cutting units. Repair and paint any damaged or bare metal surfaces.
• Lubricate all grease fittings and friction points.
• Apply a thin layer of rust preventative oil to the sharpened edges of the blades.
The cutting unit blades can have sharp edges. To prevent injury, use caution when you service or hold the blade.
After Storage
• Check and install the battery. If necessary, charge the battery.
• Check or service the fuel filter and air cleaner
• Check the level of engine oil and drive axle fluid.
• Fill the fuel tank with fuel.
• Make sure the tires are correctly inflated.
• Remove all oil from the blades.
• Start the engine at 1/2 throttle. Allow the engine to become warm and lubricated.
Never operate the engine without enough ventilation or in an enclosed area. The carbon monoxide in the exhaust
fumes can increase to dangerous levels.
!
CAUTION
!
WARNING
MAINTENANCE 9
en-48