Advertisement
Caution!
Work with only one fork leg at a time. Do not
mix the parts.
Caution!
The front fork kit is divided into one
compression cartridge and one rebound
cartridge. Important:
• Install the cartridge marked "Reb" (Rebound) in the
right side fork leg.
• Install the cartridge marked "Comp" (Compression)
in the left side fork leg.
3.1
Remove the top cap.
3.2
Remove the spring support and the preload
tube.
3.3
Remove the cylinder tube from the cartridge.
Caution!
Be careful not to damage the piston ring.
3.4
Put the cylinder tube carefully into the fork leg.
Use an extended 17 mm allen key to tighten
the cylinder tube's adaptor to the fork bottom.
Apply Loctite 243 on the adaptor's thread.
Torque 40 Nm.
Caution!
Be careful not to damage the inside of
the cylinder tube when tightening with the
extended allen key.
3.5
Pour 0,5 litre Öhlins Front Fork fuid into the
fork leg.
3.6
Put the cartridge carefully in the fork
leg. Tighten to the cylinder tube with tool
01797-07. Apply red grease on the seal
head's thread. Torque 20 Nm.
Caution!
Make sure that the piston ring is in its correct
3 - Install Öhlins Front Fork Kit
1
3
4
17 mm
allen key
4
2
Spring
support
Preload
tube
6
Advertisement
