Advertisement
3 - Install Öhlins Front Fork Kit
position and be careful not to damage it.
3.7
Open the compression and the rebound
adjuster fully. Install the top cap directly to the
shaft extension (No spring or preload tube).
Pull up the outer tube and tighten it to the top
cap. Handtighten only.
3.8
Pump out all air from the cartridge by pulling
the outer tube up and down 10-15 times.
3.9
Remove the top cap from the fork leg.
3.10
Make sure the shaft assembly is in the bottom
of the fork leg and that the outer tube is in its
bottom position. Measure the oil level with
a ruler. See set-up data and oil level-force
diagram in this folder.
3.11
Fasten tool 01765-03 on the top of the shaft
extensioner, install preload tube,spring and
upper spring support by leading them over the
tool. See the Owner's Manual for available
springs.
3.12
Pull up the shaft assembly and grab the spring
support with a 19 mm wrench.
3.13
Make sure that the comp/rebound adjusters
are fully open before installing the top cap.
Remove the pull-up tool and install the top cap
to the shaft extensioner. Torque 15 Nm.
3.14
Pull up the outer tube. Make sure the fork
leg is in a fully extended position. Use tool
00797-08 to tighten the top cap to the outer
8
Spring
11
support
13
5
10
XXX mm
11
Spring
Preload
tube
12
Spring
support
14
Advertisement
