Status Lights; Bluetooth Connection; Nfc Connection; Multipoint Connection - Rapoo A650 Quick Start Manual

Status Lights

- The green LED blinks slowly when the wired connection is successful or the Bluetooth
connection is unsuccessful.
- The blue LED blinks slowly when Bluetooth connection is successful.
- The blue LED blinks when there is an incoming call.
- The red LED blinks when the battery is low.
- The red LED is on when charging.
- The green LED is on when fully charged.

Bluetooth connection

The speaker enters into pairing mode automatically after turnning it on. Activate the Bluetooth
settings on your smartphone or other device, then search and connect to the speaker. Enter
"0000" if a password is required.

NFC connection

Activate the NFC settings on your smartphone or
other devices, place your device's NFC zone on the
speaker's NFC zone (within 1cm), the speaker will
automatically connect to your device.
This method is only available for NFC-enabled devices.

Multipoint connection

Connect device 1 and device 2 to the speaker according to the method of Bluetooth, The
speaker will work normally when connected successfully.
Note: Up to two devices can be connected to one speaker at the same time.
3