MyBinding WireMac-E Instruction Manual page 4

FOR PUNCHING DOCUMENT LARGER THAN 14" (356MM)
1. Align sheets as indicated on punch throat ruler. Make sure all dies disengagement pins are pushed in. Insert
sheets and press Foot Pedal to punch the left part first.
2. Remove sheets and flip them over as illustrated.
3. Insert sheet from right-hand-side. Press Foot Pedal to punch.
inserted in such a way as to place one of the already perforated holes onto the
1.
TIPS
The seam of closed wire should be inside the book.
Follow step No.2 instruction for best results.
TIPS
The seam of closed wire should be just touching.
Slightly adjust the Closer Control a little left or
right for the under-closed or over- closed seam.
OK
See Picture 1
See Picture 2.
See picture 3. IMPORTANT:
2.
e r g n o L 4 " 1
I N S E R T I N G
1. Insert pre-selected wire
into Wire Snatch
2. Insert document from
last pages to first
pages then insert front
cover.
The back cover should
be inserted last with
inside facing up.
3. Take out inserted
document from
Wire Snatch to close
the wire.
C L O S I N G
1. Put inserted document
into Wire Closer.
The wire element must
stand horizontally at
the bottom of Wire Closer.
2. Pull Closer Handle
forward to close.
3. Take out document
and turn back cover
over. The binding is
complete.
Document must be
Continuous Punch Guide.
3.
1.
2.
3.
1.
2.
3.