Sharp XV-Z200U Service Manual page 17

7. Removing the each other PWBs.
7-1. Remove 1 screw, and remove front R/C receiver PWB
unit .
7-2. Remove 1 screw, and remove LED PWB unit.
7-3. Remove 1 screw, and remove a terminal-2 PWB unit.
7-4. Remove 2 screws, and remove an Lamp door switch.
7-5. Remove 1 screw, and remove rear R/C receiver PWB
unit.
7-6. Remove 1 screw, and remove terminal-1 PWB unit.
8. Removing the formatter PWB.
8-1. Remove 1 screws, and remove the angle.
8-2. Remove 3 screws, and remove the blower fan unit.
8-3. Remove 2 screws, and remove the heat sink.
8-4. Remove 4 screws. Remove the backer plate M, stud
plate M, stud spring M, and 2 connectors from the
formatter PWB. After that, remove the formatter PWB.
Lamp door switch
Terminal-2 PWB
7-1
Front R/C Receiver PWB
7-2
LED PWB
DMD
Formatter PWB
Backer Plate M
Stud M
Stud Spring M
17
XV-Z200U/E, XV-Z201E
DT-300
7-4
7-5
7-3
Rear R/C Receiver PWB
Terminal-1 PWB
7-6
Lamp Shield
Angle
8-4
8-2
8-2
8-3
Heat Sink
Blower Fan Unit
8-1