Follett Maestro Plus MCD425WBS Installation Instructions Manual page 10

cabinet door
supplied air
intake grille
WARNING
• Keep ventilation openings in the
appliance enclosure clear of
obstruction. Failure to do so could
result in damage to equipment.
12"
(30.5 cm)
1.5" (38 mm)
1.75"
(45 mm)
§ Intake and Exhaust Grille Placement: air-cooled
models only
– Position the intake grille cut out in the access
panel/door
Note: Ice machine must be aligned with cut out
and inside of access panel to provide a
tight seal and prevent recirculation of hot
exhaust air.
– Left edge of cutout should be 1.75" (4.5 cm) from
the left side of the ice machine
10
air intake gasket
door & gasket
must mate
directly
cutout for supplied air intake grille
12"W x 12"H (30 cm x 30 cm)
➎
18" min.
(46 cm)
Cabinet
Door cutout
12"
(30.5 cm)
➌
Maestro Plus
Completed installation with
gasket and door in place
22.75" (57.8 cm)
Front
A: additional 3" (7.6 cm) required if
receptacle located directly behind unit.
3D Counter View
22.25 " min.
(57 cm)
12"
(30 cm)
12"
(30 cm)
– Bottom edge of cutout should be 1" (2.5 cm)
from the bottom of the ice machine
– Position supplied exhaust grille at least 18"
(46 cm) away from intake grille
possible, install exhaust grille to the rear or side
of the base cabinet.
– If not using supplied grille, air circulation
requirements must be met: 160 sq. in (1032 sq
cm) intake/exhaust air.
Side View
A
29"
(74 cm)
minimum
drain tube
➋
24" min.
(61 cm)
➍
➎
. Where
.
Vision • RIDE Technology